Oil spills on ocean waters represent a major threat to marine ecosystems. A significant part of the spilled oil is dispersed in microdroplets that are not recovered by traditional oil-removing methods. In this work, we report on the manufacture of cellulose acetate (CA) electrospun non-woven membranes, stamped with different cellulose nanocrystal (CNC) patterns. We demonstrate the use of the membranes produced as selective oil microdroplets removal from water emulsions with an efficiency up to 80%. Screenprinting was used to imprint different CNC designs on the CA surface membranes. To promote the adhesion between the CNCs and the CNCs with the CA fibers the membrane was subjected to a thermal and chemical treatments. Oil droplets were collected under water in the oleophilic CNC pattern while the water could flow through the hydrophilic CA electrospun non-woven membrane.

Lyotropic colloidal aqueous suspensions of cellulose nanocrystals (CNCs) can, after solvent evaporation, retain their chiral nematic arrangement. As water is removed the pitch value of the suspension decreases and structural colour-generating films, which are mechanically brittle in nature, can be obtained. Increasing their flexibility while keeping the chiral nematic structure and biocompatible nature is a challenging task. However, if achievable, this will promote their use in new and interesting applications. In this study, we report on the addition of different amounts of hydroxypropyl cellulose (HPC) to CNCs suspension within the coexistence of the isotropic-anisotropic phases and infer the influence of this cellulosic derivative on the properties of the obtained solid films. It was possible to add 50 wt.% of HPC to a CNCs aqueous suspension (to obtain a 50/50 solids ratio) without disrupting the LC phase of CNCs and maintaining a left-handed helical structure in the obtained films. When 30 wt.% of HPC was added to the suspension of CNCs, a strong colouration in the film was still observed. This colour shifts to the near-infrared region as the HPC content in the colloidal suspension increases to 40 wt.% or 50 wt.% The all-cellulosic composite films present an increase in the maximum strain as the concentration of HPC increases, as shown by the bending experiments and an improvement in their thermal properties.