Publications

Export 2 results:
Sort by: [ Author  (Asc)] Title Type Year
A B C D E F G H I J K L M N O P Q [R] S T U V W X Y Z   [Show ALL]
G
Godinho, D, Nogueira M, Bernardo M, Dias D, Lapa N, Fonseca I, Pinto F.  2019.  Recovery of Cr(III) by using chars from the co-gasification of agriculture and forestry wastes, Aug. Environmental Science and Pollution Research. 26:22723–22735., Number 22 AbstractWebsite

The aim of the present work was to assess the efficiency of biochars obtained from the co-gasification of blends of rice huskþinspace}+þinspace}corn cob (biochar 50CC) and rice huskþinspace}+þinspace}eucalyptus stumps (biochar 50ES), as potential renewable low-cost adsorbents for Cr(III) recovery from wastewaters. The two gasification biochars presented a weak porous structure (ABETþinspace}=þinspace}63–144 m2 g−1), but a strong alkaline character, promoted by a high content of mineral matter (59.8{%} w/w of ashes for 50CC biochar and 81.9{%} w/w for 50ES biochar). The biochars were used for Cr(III) recovery from synthetic solutions by varying the initial pH value (3, 4, and 5), liquid/solid (L/S) ratio (100–500 mL g−1), contact time (1–120 h), and initial Cr(III) concentration (10–150 mg L−1). High Cr(III) removal percentages (around 100{%}) were obtained for both biochars, due to Cr precipitation, at low L/S ratios (100 and 200 mL g−1), for the initial pH 5 and initial Cr concentration of 50 mg L−1. Under the experimental conditions in which other removal mechanisms rather than precipitation occurred, a higher removal percentage (49.9{%}) and the highest uptake capacity (6.87 mg g−1) were registered for 50CC biochar. In the equilibrium, 50ES biochar presented a Cr(III) removal percentage of 27{%} with a maximum uptake capacity of 2.58 mg g−1. The better performance on Cr(III) recovery for the biochar 50CC was attributed to its better textural properties, as well as its higher cation exchange capacity.

M
Madureira, J, Melo R, Verde SC, Matos I, Bernardo M, Noronha JP, Marga{\c c}a FMA, Fonseca IM.  2018.  Recovery of phenolic compounds from multi-component solution by a synthesized activated carbon using resorcinol and formaldehyde. Water Science and Technology. 77:456–466., Number 2: IWA Publishing AbstractWebsite

The adsorption of four phenolic compounds (gallic acid, protocatechuic acid, vanillic acid and syringic acid) is investigated using a synthesized mesoporous carbon on both single and multi-component synthetic solutions. Some correlation of the adsorption capacity of the carbon and the nature of adsorbate could be made, except for gallic acid whose concentration decrease seems to be not exclusively due to adsorption but also to polymerization reaction. In the multi-component mixture, negative effects in the adsorption capacity are observed probably due to competition for the active centers of the adsorbent surface. In desorption studies, ethanol presents better performance than water and acetonitrile. Vanillic acid is the compound with the higher adsorption and interestingly it is then possible to desorb a relatively high amount of it from the adsorbent, which may represent a possibility for a selective recovery of vanillic acid. These results present a potential way to treat the wastewater from the cork industry.