Porous carbons from digestate-derived hydrochar were produced, characterized and their performance to reclaim phosphate from water was evaluated as a preliminary approach to demonstrate their practical application. In a first step, the digestate was converted into hydrochars through hydrothermal carbonization by using two different pH conditions: 8.3 (native conditions) and 3.0 (addition of H2SO4). The resulting hydrochars did not present significant differences. Consecutively, the hydrochars were activated with KOH to produce activated carbons with enhanced textural properties. The resulting porous carbons presented marked differences: the AC native presented a lower ash content (20.3 wt%) and a higher surface area (SBET = 1106 m2/g) when compared with the AC-H2SO4 (ash content = 43.7 wt% SBET = 503 m2/g). Phosphorus, as phosphate, is a resource present in significative amount in wastewater, causing serious problems of eutrophication. Therefore, the performance of the porous carbons samples to recover phosphate – P(PO43−) – from water was evaluated through exploitation assays that included kinetic studies. The lumped model presented a good fitting to the kinetic data and the obtained uptake capacities were the same for both carbons, 12 mg P(PO43−)/g carbon. Despite the poorer textural properties of AC-H2SO4, this carbon was richer in Ca, Al, Fe, K, and Mg cations which promoted the formation of mineral complexes with phosphate anions. The results obtained in this work are promising for the future development of P(PO43−) enriched carbons that can be used thereafter as biofertilizers in soil amendment applications.

We report herein for the first-time acid biomass-derived carbons from vegetal biomass, with high developed porosity, prepared through integrating method comprising pyrolysis and surface phosphonation, able to efficiently catalyze the synthesis of quinoxalines from 1,2-diamines and α-hydroxi ketones, under aerobic conditions. The obtained results indicate that the reaction is mainly driven by a combination of acid function strength and textural properties in terms of conversion and selectivity. Furthermore, our experimental and theoretical observations suggest that the preferred reaction pathway for this transformation, in the presence of the investigated acid carbon catalysts, involves cascade reactions including imination reaction between reactants, successive imine-enamine and keto-enol tautomerisms, heterocyclization followed by dehydration, and aromatization. While the acid sites seem to be a relevant role in each reaction step, the system formed by activated carbon and molecular oxygen could be behind the last oxidative reaction to give the corresponding nitrogen heterocycles.

This work reports the synthesis of kappa-carrageenan aerogels using different dissolution and crosslinking media in order to evaluate its effects on the textural properties of the matrixes and further on the drug loading and release performance. The different aerogel samples were produced through the dissolution of the biopolymer in water with addition of potassium salts as crosslinking agents and, in two different ionic liquids (ILs) derived from imidazolium ion, being further dried with supercritical CO2. The samples were characterized by Attenuated Total Reflectance-Fourier Transform Infrared Spectroscopy (ATR-FTIR), Scanning Electron Microscopy (SEM), Nitrogen Adsorption-Desorption Analysis, Thermogravimetry (TGA) and Differential Scanning Calorimetry (DSC). The synthesized samples presented surface areas similar to the carrageenan aerogels being their structure constituted mainly by meso and macropores. The absence of ionic liquid in samples was demonstrated by DSC analysis and was corroborated by the cytotoxicity assays which revealed that cellular viability in Caco-2 cells was preserved. Tetracycline was used as a model drug and loaded in two of the prepared aerogels samples. The release experiments were performed with the composites to test in vitro drug release at physiologic pH. With a higher macroporosity, the kappa-carrageenan aerogel prepared by dissolution into ionic liquid showed a higher loading capacity than the one prepared by dissolution into water and a slightly higher release rate. The matrixes were considered to present a good potential to be used as biocompatible carriers on drug controlled delivery.

We report herein for the first-time acid biomass-derived carbons from vegetal biomass, with high developed porosity, prepared through integrating method comprising pyrolysis and surface phosphonation, able to efficiently catalyze the synthesis of quinoxalines from 1,2-diamines and α-hydroxi ketones, under aerobic conditions. The obtained results indicate that the reaction is mainly driven by a combination of acid function strength and textural properties in terms of conversion and selectivity. Furthermore, our experimental and theoretical observations suggest that the preferred reaction pathway for this transformation, in the presence of the investigated acid carbon catalysts, involves cascade reactions including imination reaction between reactants, successive imine-enamine and keto-enol tautomerisms, heterocyclization followed by dehydration, and aromatization. While the acid sites seem to be a relevant role in each reaction step, the system formed by activated carbon and molecular oxygen could be behind the last oxidative reaction to give the corresponding nitrogen heterocycles.

Mesoporous silica, SBA-15, decorated with different amounts of TiO2 (anatase) were prepared by a sol-gel method followed by hydrothermal treatment and calcination, in the presence of a soft template, copolymer Pluronic 123. Tetraethyl orthosilicate (TEOS) was used as the SiO2 precursor and commercially available TiO2 anatase nanoparticles as the supported photocatalyst. The materials were characterized by transmission electron microscopy (TEM), energy dispersive X-ray analysis (EDS), N2 adsorption-desorption isotherms, raman spectroscopy, ground state diffuse reflectance (GSDR), laser induced luminescence (LIL) and X-ray photoelectron spectroscopy (XPS). The zeta potentials of the pure SBA-15, TiO2/SBA-15 substrate and the commercial anatase sample were monitored through a complete range of pH values. All the nanomaterials developed in this work were studied in terms of their photoactivity in the UV range and in the visible range, separately. In the first case, hydroxyl radicals (OH) were confirmed to be the key active oxidizers in the photodegradation of the pesticide amicarbazone in aqueous medium. On the other hand, in the visible range, and following a dye sensitization process via a fluorescent rhodamine-like dye, two different mechanisms could be identified for the formation of the superoxide radical anion, O2−.

Heterogeneous catalysis is an exciting field in constant development. New and improved catalysts that can both be effective and economical are always on demand. Activated carbons may well play an important role in this field, as they are a cheaper alternative while more environmentally benign. In this paper, a brief overview of the effort developed in the application of activated carbon as heterogeneous catalysts in various reactions is presented. Functionalised activated carbon has been used as catalyst for fine chemical reactions. Gas-phase reactions for NO, N2O and CO2 conversions were thoroughly studied using activated carbon as catalyst support. In situ characterization techniques proved to be valuable tools to understand carbon gasification mechanism.

Rice straw (RS), rice husk (RH) and polyethylene (PE) were blended and submitted to gasification and pyrolysis processes. The chars obtained were submitted to textural, chemical, and ecotoxic characterisations, towards their possible valorisation. Gasification chars were mainly composed of ashes (73.4–89.8wt%), while pyrolysis chars were mainly composed of carbon (53.0–57.6wt%). Silicon (Si) was the major mineral element in all chars followed by alkaline and alkaline-earth metal species (AAEMs). In the pyrolysis chars, titanium (Ti) was also a major element, as the feedstock blends contained high fractions of PE which was the main source of Ti. Gasification chars showed higher surface areas (26.9–62.9m2g−1) and some microporosity, attributed to porous silica. On the contrary, pyrolysis chars did not present a porous matrix, mainly due to their high volatile matter content. The gasification bed char produced with 100% RH, at 850°C, with O2 as gasification agent, was selected for further characterization. This char presented the higher potential to be valorised as adsorbent material (higher surface area, higher content of metal cations with exchangeable capacity, and lowest concentrations of toxic heavy metals). The char was submitted to an aqueous leaching test to assess the mobility of chemical species and the ecotoxic level for V. fischeri. It was observed that metallic elements were significantly retained in the char, which was attributed mainly to its alkaline character. This alkaline condition promoted some ecotoxicity level on the char eluate that was eliminated after the pH correction.