n/a

Continuous wave terahertz (CW THz) imaging, is a variant of terahertz imaging that has been gaining scientific
and technological relevance in multiple areas. In this paper the fundamental phenomena of CW THz were
studied and a mathematical model was developed that successfully describes the Fabry–Perot interference for
such a system, opening the possibility for measurement of thicknesses and surface curvatures. The capabilities
of the system were tested using different types of defects, such as voids, water infiltrations and thin metallic
wires. The interactions between different materials, features and the radiation beam were numerically studied
using finite element method and the results agreed with the experiments. By comparing the results with other
Non-Destructive Testing methods, it was found that CW THz imaging is particularly interesting to image water
infiltrations and composite materials that incorporate conductive wires.

n/a

Polymeric parts produced by Fused Deposition Modelling (FDM) Additive Manufacturing (AM) has no special safety requirements, and therefore, NDT is not required. However, the use of AM to produce Fibre Reinforcement Thermoplastics (FRTP) parts means that structural applications with safety requirements are envisaged, demanding reliable NDT methods. This paper presents experimental results and numerical simulation by Finite Element Method (FEM) of the NDT inspection of different parts of polymeric and RFTP composite materials. The parts were produced by FDM Additive Manufacturing and different delamination defects were introduced at different positions and with different dimensions and morphologies. Two different NDT techniques were used, exploiting different inspection parameters: air-coupled ultrasound, using frequencies between 50 and 400 kHz and active transient thermography, in both reflection and transition modes. The influence of the curvature of the parts was analysed, from the experimental point of view, and the results were compared with different numerical simulation strategies. It was shown that, both NDT techniques can detect the defects, with good spatial resolution, being the thermography reflection mode the fastest and expedite for curvature parts. The numerical simulation corroborates the experimental results allowing a deeper insight on the physical phenomena involved.

This paper describes improvements to the Nondestructive Testing (NDT) technique recently proposed, based on the use of bacterial cell suspensions to identify micro- and nano-surface defects. New bacterial strains were used with magnetic fields to improve bacteria mobility. Different materials and defect morphologies were tested, including nanoindentation defects, micro-powder injection moulding components and micro-laser welding. Nanoindentations with 0.6 µm depth and 5.3 µm side length were successfully detected. Bacterial cells allow identifying different topographic attributes of the surfaces, such as roughness. Cracks of about 0.5 µm wide and 10 µm depth in a reference test block Type 1 were successfully detected.