The present work addressed the challenges of identifying applicable Non-Destructive Testing (NDT) techniques suitable for inspection and materials characterization techniques for Wire and Arc Additive Manufacturing (WAAM) parts. With the view of transferring WAAM to the industry and qualifying the manufacturing process for applications such as structural components, the quality of the produced parts needs to be assured. Thus, the main objective of this paper is to review the main NDT techniques and assess the capability of detecting WAAM defects, for inspection either in a monitoring, in-process or post-process scenario. Radiography and ultrasonic testing were experimentally tested on reference specimens in order to compare the techniques capabilities. Metallographic, hardness and electrical conductivity analysis were also applied to the same specimens for material characterization. Experimental outcomes prove that typical WAAM defects can be detected by the referred techniques. The electrical conductivity measurement may complement or substitute some destructive methods used in AM processing.

This paper describes improvements to the Nondestructive Testing (NDT) technique recently proposed, based on the use of bacterial cell suspensions to identify micro- and nano-surface defects. New bacterial strains were used with magnetic fields to improve bacteria mobility. Different materials and defect morphologies were tested, including nanoindentation defects, micro-powder injection moulding components and micro-laser welding. Nanoindentations with 0.6 µm depth and 5.3 µm side length were successfully detected. Bacterial cells allow identifying different topographic attributes of the surfaces, such as roughness. Cracks of about 0.5 µm wide and 10 µm depth in a reference test block Type 1 were successfully detected.