@article {17126,
	title = {Synthesis of thermoelectric magnesium-silicide pastes for 3D printing, electrospinning and low-pressure spray},
	journal = {Materials for Renewable and Sustainable Energy},
	volume = {8},
	year = {2019},
	pages = {21},
	abstract = {<p>In this work, eco-friendly magnesium-silicide (Mg2Si) semiconducting (n-type) thermoelectric pastes for building components concerning energy-harvesting devices through 3D printing, spray and electrospinning were synthetized and tested for the first time. The Mg2Si fine powders were obtained through the combination of ball milling and thermal annealing under Ar atmosphere. While the latter process was crucial for obtaining the desired Mg2Si phase, the ball milling was indispensable for homogenizing and reducing the grain size of the powders. The synthetized Mg2Si powders exhibited a large Seebeck coefficient of ~ 487 {\textmu}V/K and were blended with a polymeric solution in different mass ratios to adjust the paste viscosity to the different requirements of 3D printing, electrospinning and low-pressure spray. The materials produced in every single stage of the paste synthesis were characterized by a variety of techniques that unequivocally prove their viability for producing thermoelectric parts and components. These can certainly trigger further research and development in green thermoelectric generators (TEGs) capable of adopting any form or shape with enhanced thermoelectric properties. These green TEGs are meant to compete with common toxic materials such as Bi2Te3, PbTe and CoSb that have Seebeck coefficients in the range of ~ 290{\textendash}700 μV/K, similar to that of the produced Mg2Si powders and lower than that of 3D printed bulk Mg2Si pieces, measured to be ~ 4866 μV/K. Also, their measured thermal conductivities proved to be significantly lower (~ 0.2 W/mK) than that reported for Mg2Si (>= 4 W/mK). However, it is herein demonstrated that such thermoelectric properties are not stable over time. Pressureless sintering proved to be indispensable, but difficultly achievable by long thermal annealing (even above 32 h) in inert atmosphere at 400 {\textdegree}C, at least for bulk Mg2Si pieces constituted by a mean grain size of 2{\textendash}3 μm. Hence, for overcoming this sintering challenge and become the silicide{\textquoteright}s extrusion viable in the production of bulk thermoelectric parts, alternative pressureless sintering methods will have to be further explored.</p>
},
	url = {https://link.springer.com/article/10.1007\%2Fs40243-019-0159-7},
	author = {Marques, Ana and Miglietta, Davide and G. Gaspar and Baptista, Ana Catarina and Gaspar, A. and Perdig{\~a}o, P. and Iris Soares and Bianchi, Catarina and David Sousa and Bruno M. Morais Faustino and Amaral, V. S. and Santos, T. and Gon{\c c}alves, A. P. and R.C. da Silva and Giorgis, Fabrizio and Ferreira, Isabel}
}
